Front And Rear Panel Features - Keysight Technologies U3020AS62 User's And Service Manual

U3020AS62

Front and Rear Panel Features

Refer to the standard instrument documentation for damage limits to the
ports. Verify that your test setup will not cause those limits to be exceeded.
Figure 2 Front Panel
LAN Reset
Standby
Switch
Instrument State LEDs
LAN Reset
The LAN reset button restores the instrument's default LAN configuration.
Port Select LEDs
The LEDs indicate the RF Port path that is presently operational, all other port inputs are
terminated by an internal 50 Ohm load.
Input/Output Ports
There are two separate signal channels, A and B. Each channel has one output port and six input
ports. All connectors are 3.5 mm female.
Instrument State LEDs
When the power is applied to the U3020AS62, the instrument enters its power-on sequence
which requires several seconds to complete. The LEDs provide information on the state of the
instrument during power-on and during upgrades of the instrument firmware.
identifies the instrument states based on the color and functioning of the LEDs.
Standby Switch
Note that this switch is Standby only, not a line switch. The main power cord can be used as the
system disconnecting device. It disconnects the mains circuits from the mains supply.
10
Port Select LEDs
Output Ports
Front and Rear Panel Features
Input Ports
Keysight U3020AS62 User's and Service Guide
Table 6 on page 11