Configure The Ftp Server Feature - Zte ZXHN H3601 Maintenance Management Manual

ZXHN H3601 Maintenance Management Guide
Parameter
Destination IP Address
Protocol
Source Port
Destination Port
Source MAC Address
3. Click Apply button to apply the changes.

6.5 Configure the FTP Server Feature

This procedure describes how to enable the
configuring FTP parameters, including the username and password.
Steps
1. In the left navigation tree, click Local Network > FTP. The FTP Application page is
displayed, see
Figure 6-23 FTP Page
2. Set the parameters. For a description of the parameters, refer to
Table 6-16 FTP Server Parameter Descriptions
Parameter
Server
FTP Username/FTP
Password
3. Click On to enable the FTP server feature ,and click Apply button to apply the
changes.
6-20
Figure 6-23.
Description
Enable or disable the FTP server feature .
Username and password used to connect to the FTP server.Valid
only if FTP security control is enabled.
Description
Destination IPv6 address of the matching
packets.
Matching IPv6 protocol. The ANY option means
any IPv6 protocol.
Source port number of the matching packets.
Destination port number of the matching
packets.
MAC address of the source device that sends
the matching packets.
FTP feature of the ZXHN H3601 by
SJ-20200429083356-004 | 2020-07-23(R1.0)
Table 6-16.