6.10 Configure the NetSphere
The section describes how to set the device role in the mesh network.
Steps
1. In the left navigation tree, click Local Network > NetSphere to the NetSphere page,
see
Figure
Figure 6-30 NetSphere page
2. Set the device role in the mesh network. For a description of the parameters, refer to
Table
Table 6-20 Parameter Descriptions for the NetSphere
Parameter
Enable
Mode
3. Click Apply button to apply the changes.
SJ-20200429083356-004 | 2020-07-23(R1.0)
6-30.
6-20.
Description
Click On button to enable the multi-AP networking function.Click Off button,
the device is used as a common wireless router.
Setting the Device Role in the mesh Network.
Controller: set the device as the main control AP in the mesh network and
connects the LAN interface of the optical cat.
Agent: set the device as subordinate AP in the mesh network to connect
the WAN interface of the main control AP.
6 Configure the Local Network
6-25