Table of Contents
Advertisement
M0132847
Cooling system conditioner contains alkali. Alkali can
cause personal injury. Do not allow alkali to contact
the skin, the eyes, or the mouth.
Oils
Skin may be irritated following repeated or prolonged
exposure to mineral and synthetic base oils. Refer to
your suppliers Material Safety Data Sheets for
detailed information. Hot oil and lubricating
components can cause personal injury. Do not allow
hot oil to contact the skin. Appropriate personal
protective equipment should be used.
Diesel Fuel
Diesel may be irritating to the eyes, respiratory
system, and skin. Prolonged exposure to diesel may
cause various skin conditions. Appropriate personal
protective equipment should be used. Refer to
supplier Material safety Data sheets for detailed
information.
Batteries
Electrolyte is an acid. Electrolyte can cause personal
injury. Do not allow electrolyte to contact the skin or
the eyes. Always wear protective glasses for
servicing batteries. Wash hands after touching the
batteries and connectors. Use of gloves is
recommended.
Fire Prevention and Explosion
Prevention
Illustration 10
Use of personal protection equipment (PPE) may be
needed.
All fuels, most lubricants, and some coolant mixtures
are flammable.
Always perform a Walk-Around Inspection, which
may help you identify a fire hazard. Do not operate a
product when a fire hazard exists. Contact your
Perkins distributor for service.
Flammable fluids that are leaking or spilled onto hot
surfaces or onto electrical components can cause a
fire. Fire may cause personal injury and property
damage.
Flash fires may result if the covers for the engine
crankcase are removed within 15 minutes after an
emergency shutdown.
Determine whether the engine will be operated in an
environment that allows combustible gases to be
drawn into the air inlet system. These gases could
cause the engine to overspeed. Personal injury,
property damage, or engine damage could result.
If the application involves the presence of
combustible gases, consult your Perkins distributor
for additional information about suitable protection
devices.
Remove all flammable materials such as fuel, oil, and
debris from the engine. Do not allow any flammable
materials to accumulate on the engine.
All fluids that are captured in the fluid spill container
should be cleaned up immediately. Failure to clean
up spilled fluids can cause a fire. Fire may cause
personal injury and property damage.
Store fuels and lubricants in properly marked
i08625922
containers away from unauthorized persons. Store
oily rags and any flammable materials in protective
containers. Do not smoke in areas that are used for
storing flammable materials.
Do not expose the engine to any flame.
Exhaust shields (if equipped) protect hot exhaust
components from oil or fuel spray in a line, a tube, or
a seal failure. Exhaust shields must be installed
correctly.
Do not weld on lines or tanks that contain flammable
fluids. Do not use flame to cut lines or tanks that
contain flammable fluid. Clean any such lines or
tanks thoroughly with a nonflammable solvent prior to
welding or flame cutting.
Wiring must be kept in good condition. Ensure that all
electrical wires are correctly installed and securely
attached. Check all electrical wires daily. Repair any
wires that are loose or frayed before you operate the
engine. Clean all electrical connections and tighten
all electrical connections.
g00704000
Eliminate all wiring that is unattached or
unnecessary. Do not use any wires or cables that are
smaller than the recommended gauge. Do not
bypass any fuses and/or circuit breakers.
Fire Prevention and Explosion Prevention
13
Safety Section
Advertisement
Table of Contents
