Configuring Safety Digital Base Devices - ABB Scalable I/O Applications Manual

4 Software commissioning

4.5 Configuring safety digital base devices

4.5 Configuring safety digital base devices
Prerequisites
The Safety services grant is mandatory for configuration of safety digital base
devices.
Recommended work process
In order to use the safety digital base device in your Scalable I/O configuration,
the following work process is recommended:
Configure safety digital base devices via RobotStudio
Safety digital base devices are configured in the same way as the standard digital
base devices. See
Configure safety digital base devices via FlexPendant
Continues on next page
72
• Install the safety digital base device, see
on page 45.
• Configure the safety digital base device, see
using RobotStudio on page
Note
When working with safety digital base devices, the configuration tool will
update and download a new safety configuration to the controller.
• After the configuration, the dual channels must be defined using CL logic,
see Setting up dual channel signals on page 73
manual - Functional safety and SafeMove for instructions on how to define
logic diagrams.
• Verify the parameters in the ABB Safety Configuration Report, see
parameters in the ABB Safety Configuration Report on page
• When the set-up and configuration is done, see Application
manual - Functional safety and SafeMove for instructions on how to work
with the safety configuration.
Configuring Scalable I/O devices using RobotStudio on page
Note
Safety digital base devices cannot be configured using the FlexPendant.
© Copyright 2019-2022 ABB. All rights reserved.
Installing safety digital base devices
Configuring Scalable I/O devices
58.
and Application
Application manual - Scalable I/O
Verifying
74.
58.
3HAC070208-001 Revision: F