Back Cards For The Ausm/B; Table 2-3 Eight-Port Ausm/B Led Indicators - Cisco MGX 8230 Installation And Configuration Manual

ATM UNI Service Module (AUSM)
Table 2-3
Table 2-3
Type of LED
PORT LED
ACTIVE LED
STANDBY LED
FAIL LED

Back Cards for the AUSM/B

The MGX-AUSM-8T1/B and MGX-AUSM-8E1/B use the generic eight-port T1 or E1 line modules that
operate with the eight-port service modules (see
•
•
•
1:N Redundancy support for the AUSM requires the special versions of the RJ-45 back cards
(Figure 2-11 on page
•
•
•
Note Redundancy support differs for the MGX-AUSM-8T1/B and MGX-AUSM-8E1/B. For details on the
requirements for redundancy through an MGX-SRM-3T3/C, refer to
page
Cisco MGX 8230 Edge Concentrator Installation and Configuration
2-18
contains a list of eight-port LED indicators:
Eight-Port AUSM/B LED Indicators
Color
Green
Red
Yellow
Green
Yellow
Red
AX-RJ48-T1: provides eight RJ-48 connectors for T1 lines.
AX-RJ48-E1: provides eight RJ-48 connectors for E1 lines.
AX-SMB-E1: provides eight pairs of SMB connectors for E1 lines.
2-19). These back cards are:
AX-R-RJ48-T1
AX-R-RJ48-E1
AX-R-SMB-E1
2-12."
Description
Green indicates the port is active.
Red indicates a local alarm on the port.
Yellow indicates a remote alarm on the port.
Off indicates the port has not been activated (upped).
On indicates the card set is in active mode.
Slow blink with Active LED off means the card is in the boot
state.
Fast blink with Standby LED on means card is receiving
firmware.
Fast blink indicates the service module is passing BRAM channel
information to the PXM1.
Steady yellow indicates the card is in Standby mode and the
firmware is executing ADMIN code.
Steady Red with Active and Standby LEDs off indicates either the
card is in the Reset condition, the card has failed, or the card set
is not complete (no line module).
Steady Red with Active LED on indicates the card was active
prior to failing.
Steady Red with Standby LED on indicates the card was standby
prior to failing.
Figure 2-11 on page
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
Chapter 2 Module and Service Descriptions
2-19).
"Service Resource Module,