Chapter 6
Card and Service Configuration
EgSrvRate
•
EgrPcUtil
•
cnfupcvbr has the same syntax and parameters as cnfupcabr
cnfupcvbr or cnfupcabr <port.vpi.vci> <enable> <pcr[0+1]> <cdvt[0+1]> <scr> <scr_police> <mbs>
<IngPcUtil> <EgSrvRate> <EgPcUtil> <clp_tag>
port.vpi.vci identifies the connection.
•
enable
•
•
pcr
•
cdvt
scr
•
scr_police specifies the type of scr policing: 1= CLP[0] cells,
•
•
mbs
•
IngPcUtil is the percent utilization on the egress. The range is 1–127. The
Release 1.1.31, Part Number 78-11215-03 Rev. B0, May 2001
is the egress service rate. Without IMA, the range is as follows:
T1, 10–3622 cells per second
–
E1, 10–4528 cells per second
–
clear E1, 10–4830 cells per second
–
For IMA, multiply the line rate by the number of links.
is the percent utilization on the egress. The range is 1–127.
The default is 0.
is the enabled/disable for UPC: 1=Disable, 2=Enable.
is the peak cell rate. Without IMA, the range is as follows:
–
T1, 10–3622 cells per second
–
E1, 10–4528 cells per second
–
clear E1, 10–4830 cells per second
For IMA, multiply the line rate by the number of links.
cdvt[0+1] is the cell delay variation tolerance for cells with
CLP=[0+1]. The range is 1–250000 micro seconds.
is the peak cell rate. Without IMA, the range is as follows:
T1, 10–3622 cells per second
–
–
E1, 10–4528 cells per second
–
clear E1, 10–4830 cells per second
For IMA, multiply the line rate by the number of links.
2=CLP[0+1] cells, and 3=no SCR policing.
is the maximum burst size: the range is 1–5000 cells.
default is 0.
Cisco MGX 8230 Edge Concentrator Installation and Configuration
ATM Universal Service Module (AUSM)
6-19