Direct IP IDIS DC-S1163 Series Operation Manual page 36

Part 1 - Remote Setup
- Preference: Designate recording stream priority.
Recording using the Time-Lapse/
SD
Pre-Event and Event streams
Recording
designated above.
Record from the remote program
using the designated recording
streams. If the remote program
Network
does not support recording
Recording
streams, however, Default
Recording Stream specified under
Video > Streaming will be used.
Record using the SD Recording
stream or the Network Recording
None
stream, whichever has the higher
resolution.
• Network Recording Failover: Select a network
recording failover mode. You can recording video on
the SD memory card when recording from the remote
program fails. Video is recorded using the stream
designated under Recording Stream > Event.
Not supported if the recording mode under the
Schedule tab is set to Always > Time-Lapse.
36
- Off: Disables Network Recording Failover.
- Always: Records video continuously until recording
from the remote program becomes functional
again, regardless of the recording schedule.
- On SD Schedule: Records video based on the
recording schedule set up under the Schedule tab
until recording from the remote program becomes
functional again.
• Recordings saved on the SD memory card can be
searched and played back from the IDIS Solution
Suite Compact program or remotely from the
remote program. For more information, refer to
each program's operation manual.
• Video search and playback may not function
properly on the remote program while video is
being recorded on to the SD memory card.
To remove the SD memory card, unselect the Record
option and wait 30 seconds before doing so. Removing
the SD memory card while recording is in progress of
without waiting 30 seconds can damage the system
and/or the recording data.