Direct IP IDIS DC-S1163 Series Operation Manual page 19

Exposure
Configure Exposure settings.
• AE Target Gain: Specify exposure compensation's
target gain. Exposure is compensated automatically
based on the specified target gain. Higher the gain,
brighter the images.
• Local Exposure: Activate Local Exposure. Use Local
Exposure on images that appear too dark due to
backlighting conditions and on images containing
over-exposed sections. Dark parking lot entrances
and gas station entrances at night, for example (Local
Exposure compensates for the bright light coming
from incoming vehicle headlights and makes it
possible to see the license plates). Greater the value,
clearer the image.
• Anti-Flicker: If the lights in the area where the
camera is located use alternating current, specify
the frequency of the lights to minimize flickering.
Matching the frequencies can reduce flickering.
(NTSC: 60Hz, PAL: 50Hz)
• Slow Shutter: Activate Slow Shutter. The electronic
shutter's speed will decrease to the specified level
under low-lighting conditions to allow more light in
and therefore produce brighter images.
• DC IRIS: Select the lens IRIS type.
- Auto: The system will assess the lighting conditions
and adjust the openness of IRIS automatically.
- Full Open: Open the lens IRIS fully and accept light
as much as possible.
• Exposure Control: Adjust Shutter Speed and gain.
This option is available only when Anti-Flicker and
Slow Shutter are both set to Off.
- Auto: The system will assess the lighting
conditions and adjust the shutter speed and gain
automatically.
- Manual: Use the slider to select the desired shutter
speed and gain. Select the most suitable minimum
and maximum shutter speeds and gains for the
lighting conditions in the area where the camera is
located.
With certain features, selecting Auto automatically
loads settings suitable for the camera's installation
environment.
Part 1 - Remote Setup
19