Cli Prompt - Cisco XR 12000 Series Getting Started Manual

Chapter 3 Configuring General Router Features
If you log in to a router with a single SDR configured (this is the default configuration), you can manage
the entire router.. If you log in to a named SDR, you can manage only that SDR. For more information
on SDRs, see the
When you log in, the username and password may be validated by any of the following services:
•
•
•
•
•
The username and password validation method that your router uses is determined by the router
configuration. For information on configuring username and password validation methods, see
Cisco IOS XR System Security Configuration Guide for the Cisco XR 12000 Series Router. For
information on which username and password to use, see your system administrator.
To log in to the router, enter your username and password when prompted. For example:
User Access Verification
Username: iosxr
Password: password
RP/0/0/CPU0:router#
Note Passwords are case sensitive. To log in to an SDR using a root-system username from the owner SDR,
enter the username in the following format: username@admin. To support admin login, local database
authentication must be enabled with the aaa authentication login remote local command. For more
information, see Cisco IOS XR System Security Configuration Guide for the Cisco XR 12000 Series
Router.
After you log in, the router displays the CLI prompt, which is described in the
page
For information on how privileges are assigned to usernames, see Cisco IOS XR System Security
Configuration Guide for the Cisco XR 12000 Series Router.

CLI Prompt

After you log in, you see the CLI prompt for the Cisco IOS XR software. This prompt identifies the
router or SDR to which you are issuing commands. The CLI prompt represents the path, through the
router, to the CPU that executes the commands you enter. The syntax for the CLI prompt is:
type/rack/slot/module: router-name#.
Table 3-1
Prompt Syntax Component
type
rack
OL-24755-01
"Secure Domain Routers" section on page
Usernames configured on the router (username command in global configuration mode)
Root-system usernames configured on the owner SDR
Passwords configured for the router console and auxiliary ports (password or secret command in
line configuration mode)
RADIUS server
TACACS+ server
3-37. The command set that you can use is determined by the privileges assigned to your username.
CLI Prompt Description
Table 3-1 describes the CLI prompt.
Description
Type of interface or card with which you are communicating. For
most user communication tasks, the type is "RP".
Rack number. In a standalone router, the rack number is always "0".
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
3-27.
"CLI Prompt" section on

CLI Prompt

3-37