Table of Contents
Advertisement
Quick Start Guide
GFK-2851A
supply, and CPU in the Project tab of the Navigator, go online
with the target, right-click on the target and select Online
Commands, Show Status..., Details, to display the Device
Information Details window. This queries the CPU and all modules
present on all racks in the system, whether configured or not. If
the ECM850 is displayed in the list similar to the following
screenshot, it indicates that the module has powered up as
expected, is communicating with the CPU over the rack
backplane, and that it is ready for further configuration.
Next Steps
3.2.
The full configuration of the ECM850 is beyond the scope of this
Guide, but is covered in detail in the User Manual, GFK-2849,
referenced in section 5. In brief, the steps are the following:
1.
Add ECM850 to RX3i Target Hardware Configuration:
select the slot in which the ECM850 is installed, right-click
and select Add Module. From the Communications tab of
Status and Diagnastic Data
Chapter 3
Sep 2019
24
Advertisement
Table of Contents
