Emerson PACSystems RX3i IC695ECM850 Quick Start Manual page 19

Quick Start Guide
GFK-2851A
•
Swing the module down until the module's connector
engages the backplane's backplane connector.
•
Visually inspect the module to be sure it is properly
seated.
•
Turn the heat sink screw on the front of the module
several turns into the threaded hole in the backplate
using a flat-tip screwdriver, but do not tighten.
•
Insert the two provided M3x5 machine screws through
the module's bottom bracket into threaded holes in the
bottom of the backplate and screw them several turns
using a #1 Phillips screwdriver, but do not tighten.
•
Tighten the heat sink screw to 6 in-lbs (0.7 N-m).
•
Tighten the bottom bracket screws.
Hardware Installation
Chapter 2
Sep 2019
18