Introduction; General Information - Zeiss Mechanical stage S mot. Operating Manual

Carl Zeiss
1

INTRODUCTION

1.1

General information

The mechanical / measuring stage S 150 x 100 mot. CAN and the appropriate controller EMS 3 have
been designed, manufactured and tested in compliance with DIN EN 61010-1 (IEC 61010-1) Safety
requirements for electrical equipment for measurement, control and laboratory use.
Mechanical / measuring stage S 150 x 100 mot. CAN satisfies the requirements of the European
directives 2006/95/EC "Low Voltage Directive", 2004/108/EC "Electromagnetic Compatibility" and
2006/42/EC "Machinery Directive" with the appropriate controller EMS 3.
The operating manual contains all information and warnings the operator must comply with.
The following warning and information symbols are used in this operating manual:
CAUTION
This symbol indicates a potential hazard to the user.
CAUTION
Optical radiation is emitted. Do not look into the laser beam!
This may be harmful to the eyes (see Section 2.4).
CAUTION
Risk of pinching!
CAUTION
Hot surface!
CAUTION: High-energy UV radiation!
Risk of injury to eyes and skin!
CAUTION
Disconnect the instrument from the power supply before opening!
ATTENTION
This symbol indicates a potential hazard to the instrument or system.
NOTE
This symbol indicates an instruction which requires particular attention.
6
INTRODUCTION
General information
435465-9000-701
Mechanical stage S mot. CAN
Measuring stage S mot. CAN
08/2012