Emerson Rosemount 3144P Reference Manual page 69

Reference Manual
00809-0100-4021, Rev AA
March 2002
Message
There are write only
variables which have
not been edited.
Please edit them
There is unsent data. Send
it before shutting off?
Too few data
bytes received
Transmitter fault
Units for <variable label>
has changed. Unit must be
sent before editing, or
invalid data will be sent.
Unsent data to online
device. SEND or
LOSE data
Use up/down arrows to
change contrast. Press
DONE when done.
Value out of range
<message> occurred
reading/writing
<variable label>
<variable label> has an
unknown value. Unit must
be sent before editing, or
invalid data will be sent.
Description
There are write-only variables that have not been set by the user.
These variables should be set or invalid values may be sent to
the device.
Press YES to send unsent data and turn the HART
Communicator off. Press NO to turn the HART Communicator off
and lose the unsent data.
Command returns fewer data bytes than expected as determined
by the device description.
Device returns a command response indicating a fault with the
connected device.
The engineering units for this variable have been edited. Send
engineering units to the device before editing this variable.
There is unsent data for a previously connected device which
must be sent or thrown away before connecting to another
device.
Gives direction to change the contrast of the HART
Communicator display.
The user-entered value is either not within the range for the given
type and size of variable or not within the min/max specified by
the device.
Either a read/write command indicates too few data bytes
received, transmitter fault, invalid response code, invalid
response command, invalid reply data field, or failed pre- or
post-read method; or a response code of any class other than
SUCCESS is returned reading a particular variable.
A variable related to this variable has been edited. Send related
variable to the device before editing this variable.
Model 3144P
4-9