Modifying Rules - Cisco PXM Version 1.1 User Manual

Chapter4 CSR GUI Functionalities
•
•
Note
•
•
Step 9
Click Add to add this rule, or click Cancel to exit.

Modifying Rules

Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Rules from the pull-down menu.
Step 2
In the Rule area, select a rule by double-clicking the rule. Rule information similar to the following
appears
Select Same Carrier—If the ingress carrier is also a egress carrier candidate, it is selected and all
others are deselected.
Select Percentage Egress—Carriers with a zero percentage egress and sharing the greatest
difference between their percentage egress and their maximum percentage egress are selected. The
purpose is to select the best egress carrier candidates that are furthest from meeting their provisioned
maxPercentage on this route (based on their Egress Routing Attribute's maxPercentage value).The
other carriers are moved to the deselect list.
Carriers with a null maxPercentage value are not moved to the deselect list.
Select Preferred Carrier—If the preferred carrier is an egress carrier candidate, it is selected and all
others are deselected. When this is selected, click the down arrow in the Preferred Carrier box. A
preferred carrier pull-down menu appears.
Percentage Termination—Find the best candidate egress carriers farthest from meeting their
provisioned maximum percentage on this route. This is based on their Egress Routing Attribute's
maxPercentage value. The other carriers, except those with a null maxPercentage value, are then
moved to the "deselect" list.
(Figure4-36 "Dialog Box for Existing Rule in Active
Updating Active Datasets
Dataset"):
Cisco Carrier Sensitive Routing User Guide
4-37