Modifying Routes - Cisco PXM Version 1.1 User Manual

Chapter4 CSR GUI Functionalities
Figure4-33 QoS Relationships Dialog Box in Active Dataset
a.
b.
c.
d.
e.
Step 6
In the Available Patterns box, select a pattern and click Add to add a pattern to the route. The patterns
in this box are not bound to this route until they are added to the Patterns in Route box. Click Remove
to remove a pattern bound to the route.
Note
Step 7
Click Add to add this route, or click Cancel to exit.

Modifying Routes

Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Match Patterns from the pull-down menu.
Step 2
In the Routes area, select a route by double-clicking the route. Routes information similar to the
following appears
In the Ingress Carrier box, click the down arrow, then select the ingress carrier from the pull-down
menu.
In the Egress Carrier box, click the down arrow, then select the egress carrier from the pull-down
menu.
In the QoS Value box, enter a number larger than zero.
Click Add or Remove to add or remove the QoS relationship.
Click OK to complete adding the relationship or click Cancel to exit without adding the
relationship.
A pattern can be bounded to only one route at a time. If you add a pattern to the Patterns in
Route list, that pattern is removed from all other routes.
(Figure4-34 "Dialog Box for an Existing Route in Active Dataset
Updating Active Datasets
Cisco Carrier Sensitive Routing User Guide
"):
4-33