Cisco PXM Version 1.1 User Manual page 46

Configuring CSR with the GUI
Step 2
nter the ID of the gatekeeper to be added. The range is 1 to 64 characters.
Step 3
nter remote address (IP address) of the gatekeeper to be connected to. The format is x.x.x.x where x is
a number from 0 to 255.
Step 4
nter port on the gatekeeper used for connection. The range is 1 to 32767.
Step 5
Click Connected or Disconnected to connect the gatekeeper to or disconnect the gatekeeper from the
CSR. The default is Connected.
Step 6
To select a message to be associated with the gatekeeper, check the checkbox next to the message shown,
as follows
Figure4-5
Step 7
To display the existing filters for the message, click the round button to the far left of the message. The
following screen appears
Box"):
Figure4-6
Step 8
To add a filter to a message, right click the icon to the left of the message. A pop-up menu containing
the available filters appears
Cisco Carrier Sensitive Routing User Guide
4-6
(Figure4-5 "Registered Messages and Filters Checkbox
Registered Messages and Filters Checkbox
(Figure4-6 "Filter display in the Registered Messages and Filters Dialog
Filter display in the Registered Messages and Filters Dialog Box
(Figure4-7 "Filters Pop-up
Chapter4
"):
Menu"):
CSR GUI Functionalities