Table of Contents
Advertisement
Chapter4
CSR GUI Functionalities
Step 10
In the Date/Time area, click Daily, Weekly, Absolute or Constant . The egress route attribute is being
applied according to these time segments.
a.
b.
c.
d.
Note
Step 11
In the Available Routes box, click Add or Remove to add or remove a route from the Associated Routes
box respectively.
Step 12
Click Add to add this egress route attribute, or click Cancel to exit.
Modifying Egress Route Attributes
Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Egress Route Attributes from the pull-down menu.
Step 2
Click the down arrow in the Carriers box, then select the appropriate carrier from the pull-down menu.
A list of Egress Route Attribute names of the selected carrier appears (
Attribute Names in Active
If you select Daily, enter Start Time and End Time. Use the format shown in the example at the
bottom of the Date/Time area:
hour(0-23):min (0-60):sec (0-60)
If you select Weekly, select day of the week from the pull-down menu and enter the Start Time and
the End Time.
If you select Absolute, enter the Start Date, Start Time, End Date, and End Time.
The Start Date is the date when the egress route attribute becomes active. The End Date is the date
when it becomes inactive. Use the formats shown in the example at the bottom of the Date/Time
area:
4 digit year-2 digit month-2 digit day
hour(0-23):min (0-60):sec (0-60)
If you select Constant, the egress route attribute is applied at all times of all days.
If two RouteAttributes exist in the same timeframe with the same date and time constraint,
the RouteAttribute is "nondeterminstic." That is, the order of selection among time intervals
of the same type that overlap cannot be determined.
Dataset"):
for date, as in 2002-12-03
for time, as in 12:59:10
Cisco Carrier Sensitive Routing User Guide
Updating Active Datasets
Figure4-26 "List of Egress Route
4-23
Advertisement
Table of Contents
