Modifying Carriers - Cisco PXM Version 1.1 User Manual

Chapter4 CSR GUI Functionalities
Figure4-18 Dialog Box for New Carrier in Active Dataset
The carrier key is the primary key of this carrier in the Carriers table. When a new carrier is being
created, " %%%%" is displayed.
Step 3
In the Carrier ID box, enter the ID of the carrier. The range is 1 to 64 characters.
Step 4
In the Carrier name box, enter name of the carrier. The range is 1 to 64 characters.
Step 5
In the Carrier Type box, click the down arrow, then select the type of carrier from the pull-down menu.
Step 6
In the Max Ingress Units box, enter the maximum number of ingress units this carrier may originate
across all routes serviced by this carrier. The range is 0 to 2147483647. This is optional.
Step 7
In the Rule box, click the down arrow, then select the rule this carrier applies to from the pull-down
menu.
Step 8
In the Max Egress Units box, enter the maximum number of egress units that this carrier may terminate
across all routes serviced by this carrier. The range is 0 to 2147483647. This is optional.
Step 9
In the Contact List box, click the down arrow, then select the contact list that this carrier applies to from
the pull-down menu.
Step 10
To make this carrier active, click the checkbox to the left of "Active."
Step 11
Click Add to add this carrier to the provisioned data, or click Cancel to exit.

Modifying Carriers

Step 1
In the Active Dataset tab in the CSR window, if "Carrier" is not selected in the Selection box, click the
down arrow in that box, then select Carrier from the pull-down menu.
Step 2
In the Carriers area, select a carrier by double-clicking that carrier on the list. Carrier information similar
to the following appears (Figure4-19 "Dialog Box for an Existing Carrier in Active
Updating Active Datasets
Cisco Carrier Sensitive Routing User Guide
Dataset"):
4-15