Ancillary Service Information - Daniela DAN2GTS User Manual

ANCILLARY SERVICE INFORMATION

• SERVICE TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON!
• DO NOT ATTEMPT ANY REPAIRS YOURSELF.
• DO NOT MODIFY APPLIANCE!
• ALWAYS ENSURE THAT THE GAS AND ELECTRICAL SUPPLY
IS DISCONNECTED BEFORE SERVICING APPLIANCE.
• It is also recommended that this appliance be serviced at 12 month minimum.
ELECTRICAL EQUIPMENT AND COMPONENTS
• ALWAYS ENSURE THAT THE POWER SUPPLY IS DISCONNECTED BEFORE
SERVICING THE APPLIANCE.
• The electrical component is primarily located below the hob surface. Removal of the hob is
straightforward by removing the control knobs, the trivets, the burner caps and burner head
assemblies and skirts.
• Using a flat bladed screwdriver remove the five screws, one in each corner of the hotplates
left and right spillage bowls and one centrally located at the rear of the centre spillage bowl.
• Then lift the hob upwards. Replacement is a reversal of the above procedure.
• Care must be taken to ensure that no damage occurs to the spark ignition leads or the
igniters. The electronic ignition pack is easily accessible for service or replacement below
the hob centrally at the rear.
GAS CONTROLS AND GAS MANIFOLD
• Removal of the gas manifold is initially accomplished by removing the control knobs, the
trivets, the burner caps and burner head assemblies and skirts.
• Using a flat bladed screwdriver remove the five screws, one in each corner of the hotplates
left and right spillage bowls and one centrally located at the rear of the centre spillage bowl.
• Care must be taken to ensure that no damage occurs to the spark ignition leads, igniters
or thermocouples, if fitted. Disconnect all ancillary gas piping. Remove the two securing
brackets at the front and also the securing bracket near the gas inlet point to the burner
compartment. The gas manifold may then be extracted.
• Replacement is reversal of the above procedure.
PA G E 1 2
P I 02 9604 1226 E I sales@danielaappliances.com.au W | danielaappliances.com.au