Table of Contents
Advertisement
Natural Gas Regulator
INSTALLATION - ELECTRICAL CONNECTION
BEFORE CONNECTING THE PLUG INTO THE POWER SOCKET,
FOLLOW THESE INSTRUCTIONS:-
•
The electrical supply for the upright cooker must be a 240Volt 50 Hz.
•
The fuse and electrical wiring of the home / premises must support the load of the appliance.
•
The 3-pin plug, used to connect the electricity, must be easily reached when the hotplate is
in its installed position.
•
The hotplate must be earthed. Connect the hotplate to a properly earthed and rated power
socket, as appropriate.
•
The flexible cord of the appliance must not be subject to direct heat and must be positioned
after installation of the hotplate so that its temperature does not exceed 75ºC.
IMPORTANT: If a power socket needs to be installed or relocated, the work must be carried out
by a licensed electrician.
PA G E 1 0
P
I
02 9604 1226
E
I
sales@danielaappliances.com.au
UNDER NO CIRCUMSTANCES USE A NAKED
FLAME WHEN CHECKING FOR LEAKS.
•
Check Gas Adjustments (refer INSTALLATION
– GAS CHECKS AND ADJUSTMENTS)
•
Ensure the appliance operating pressure
is adjusted and set according to these
instructions and local authority requirements.
When satisfied that the hotplate is operating
correctly, instruct the customer in its safe
operation. Ensure the customer understands
fully by having them operate the hotplate and
all its functions.
W
|
danielaappliances.com.au
Advertisement
Table of Contents
