Install The Water Inlet Hose - Haier HWM60-728 User Manual

Install the water inlet hose

Confirm the water faucet
water faucet, suitable
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth. If not please file it to avoid
leakage.
Connection between the water inlet hose jointer and the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the water
inlet hose jointer from the water inlet hose component. See to Figure 1.
2 Loosen the screw till the water faucet can be accessed. Put the jointer of the water
inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can
not be set on the water faucet, please loosen the four screws and take out the bushing
in the jointer. The front end of the faucet must be smooth, otherwise it may leak water.
See to Figure 3.)
Lock lever
water inlet hose
3.Fasten the four screws evenly. See to Figure 4.
4 Take off the nameplate. Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
Remark: Before installation, the threading is 4mm above the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut.
See to figure 6.
Figure 4
The exit end face of the faucet
water inlet hose jointer
Slider
Screw knife
Figure 1
Figure 5
water faucet, not suitable
Sign plate
Figure 2
Screw nut
Figure 6
6
Screw
Bushing
Figure 3
About 4mm before twisting
About less than 2mm after twisting