Gently press down the SODIMM using your index fingers, distributing even pressure across the module
Step 9
until it locks into the tabs
Excessive pressure can damage a SODIMM socket.
Caution
Verify that the release levers are flush against the side of the socket. If they are not, the SODIMM might
Step 10
not be seated properly.
If the module appears misaligned, carefully remove it and reseat it, ensuring that the release lever is flush
Step 11
against the side of the SODIMM socket.
If there is a retaining clip, insert it by sliding the clip between the metal strain relief and the plastic latch
Step 12
(Figure
Figure 31
The clip is properly installed when the clip detente protrudes below the strain relief and plastic latch
(Figure
OL-13004-01
(Figure
31).
Inserting the Retaining Clip
32).
30b).
ATM Line Card Installation and Configuration
Line Card Memory
57