Mitsubishi Electric FR-C500 Instruction Manual page 132

(2) Set frequency (RAM) (D9144)
The D9144 data is written to the RAM as a set frequency. The unit is 0.01Hz.
(For example, 6000 indicates 60.00Hz.)
The range where the frequency can be set is 0 to 12000 (0 to 120.00Hz).
When the frequency setting is written normally, the write completion signal (X24)
turns on, and at the same time, 0 is set to D9150.
If any value outside the range is written, HFFFF is set to D9150 as soon as the
write completion signal (X24) turns on, resulting in abnormal completion. If
abnormal completion occurs, the set frequency is not changed.
POINT
• Although the setting unit is 0.01Hz, the actual operation is performed in
0.1Hz units.
• The frequency can be set in the PU operation mode and CC-Link operation
mode. (Refer to page 75.)
<Set frequency write (RAM) program example>
The following program changes the set frequency (RAM) to 30Hz.
Set frequency write (RAM) setting request
Inv erte r Sta tus M o nito rin g , S pe cial R egiste rs for
Normal write
Abnormal write
123
C o ntrol
Turns on set frequency
write (RAM) command pulse.
Check whether set frequency
write (RAM) completion signal
turned on to judge whether write
was performed normally or not.
Stores 3000 (30Hz) into D9144,
and turns on set frequency write
(RAM) command.
(Until completion signal turns on)
4