Table of Contents
Advertisement
Installation of the Inverter
! Install the inverter under the following conditions:
Vertical mounting
Vertical
! The inverter consists of precision mechanical and electronic parts. Never install or
handle it in any of the following conditions as doing so could cause an operation
fault or failure.
Direct sunlight
Vertical mounting (When
mounted inside enclosure)
! Removal and reinstallation of the front
cover
Remove the front cover by pulling it
toward you in the direction of arrow.
To reinstall, match the cover to the inverter
front and install it straight.
! Removal and reinstallation of the wiring cover
The cover can be removed easily by pulling it toward
you.
To reinstall, fit the cover to the inverter along the guides.
! Wiring of the RS-485 communication connector
When using the RS-485 connector to wire the cable, you
can cut off the lug of the wiring cover to wire it.
Ambient temperature and humidity
Temperature: -10
Humidity: 90%RH maximum
Vibration
(5.9m/s
2
max.)
Transportation by
holding front cover
4
1cm or
more
C
to 50
C
Clearances also necessary for
changing the cooling fan.
(1.5K or more)
High temperature,
high humidity
Oil mist,
flammable gas,
corrosive gas,
fluff, dust, etc.
FR-C520-0.1K to 0.75K
Lug
Clearances
10cm or
more
1cm or
more
10cm or
more
Horizontal placement
Mounting to
combustible material
FR-C520-1.5K to 3.7K
Wiring
cover
Advertisement
Table of Contents
