Table of Contents
Advertisement
14. Install Arm Restraints & Lifting Arms
A. Position the arm restraint gears with pin against the bottom of the arms in the orientation shown in
Fig.13a. Attach the gears to the arms with bolts. Do not tighten at this time.
Swing Arm
Pin
Gear
Fig. 13a
B. Position the arm restraint pawls on the carriage to mate with the gears on the arms.
C. Install the swing arms to the carriages using the pins, as shown in Fig. 13a & b. Secure pin to
carriage with clip at bottom of pin.
Suggestion: Position Long Arms to rear or 'drive-in' end of the lift, with Short Arms (L&R) to the front.
DON'T FORCE THE GEARS, IT MAY BE NECESSARY TO PULL UP ON THE RESTRAINT ACTUATOR PIN
IN ORDER TO INSTALL THE SWING ARM PIN.
D. Tighten the arm restraint gear bolts to 30 – 34 ft. lbs.
E. Assemble the arm extensions & lifting pads. Limit arm extensions with bolt & nuts. (Fig.14a & 14b)
Pawl
Fig. 14a (Front Arm)
22
TP10KAC-DX
July 2018
Fig. 13b
Limit Bolt / Nut
Advertisement
Table of Contents
