Table of Contents
Advertisement
7. Install Overhead Limit Switch & Overhead Beam (Figs. 6a, 6b & 6c)
A. Install overhead limit switch assembly to overhead beam, using 2ea 1/4"-20 Bolt & Lock Nuts as
shown in figs 6a, 6b & 6c.
B. Slide end of padded bar (without a mounting hole) through the slot in the overhead switch
assembly. Connect the padded bar to the inside hole in the overhead beam using a spacer and
1/4"-20 Bolt & Lock Nut
Overhead Limit
Switch Assembly
Fig. 6a
Position Overhead Limit Switch
Assembly on same side as power unit.
TP10KAC-DX
Fig. 6c
15
July 2018
Fig. 6b
Overhead Limit
Switch Cable
Advertisement
Table of Contents
