Landscape Forms Lo-Glo Installation Manual

Lo-Glo
Path Light
Installation Guide
Lo-Glo Lo-Glo with
With cover plate
paver adapter
Included hardware
1x – LED driver
1x – anchor
template
1x – Security
3x – 5/16-18 x
hex key
1-1/4" HBOLT
Tools Required
• Safety glasses
• Screwdrivers
• Wiring tools and connectors
• Masonry drill, with Ø5/8" bit
• Compressed air and wire brush
• Epoxy anchoring system for concrete
• Wrench, 1/2"
LIGHTING LAYOUT RECOMMENDATIONS:
Refer to Lo-Glo's product data sheet at
ASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long-lasting finish. To
protect this finish during assembly, place unwrapped powdercoated parts on packaging foam
or other non-marring surface. Do not place or slide powdercoated parts on concrete or other
hard or textured surface – this will damage the finish causing rust to occur. Use touch-up paint
on any gouges in the finish caused by assembly tools.
3x – concrete
anchor
1x – Access
panel cover
3x – 11/32 ID
washer
www.landscapeforms.com for more information.
Landscape Forms is not responsible for site preparation and footings. Footing
recommendations are included in these instructions.
Fig. 1 – Minimum footing recommendation
EDGE OR
EXPANSION
JOINT
Fig. 2 – Minimum concrete slab size
Date: March 19, 2021
www.landscapeforms.com Ph: 800.521.2546
Fig. 3 – Assemble anchor template
Fig. 4 – Proper orientation
of conduit
COVER PLATE
HEX BOLT AND
WASHER
CONCRETE ANCHOR
Fig. 5 – Recommended setback
from sidewalk
HEX BOLT
WASHER
TEMPLATE
CONCRETE
ANCHOR
Page 1 of 2