Table of Contents
Advertisement
operating instructions
Operating Instructions
Before operating this appliance, proceed through
the following checklist.
1. Read and understand these instructions before
operating this appliance.
2. Check to see that all wiring is correct and
enclosed to prevent possible shock.
3. Check to ensure there are no gas leaks.
4. Make sure the glass door is in place. Never oper-
ate the appliance with the door glass removed.
5. Verify that the venting and the cap is
unobstructed.
6. Verify the placement of logs and other decora-
tive media. If the pilot cannot be seen when
lighting the unit, the logs/media are incorrectly
positioned.
7. DO NOT turn the unit off and on without first
waiting 60 seconds.
8. When lighting the appliance, the inside of the
glass may fog. This will burn off after a few
minutes of operation.
DO NOT BURN THE APPLIANCE WITH
THE GLASS DOOR REMOVED.
Lighting Procedure
The remote control system supplied with this
appliance has an ON/OFF key on the hand
held transmitter.
Prior to operating this appliance, please
read the remote control operating instruc-
tions (packaged with remote control) to
understand how to operate this remote
control system.
1. Press and release the ON/OFF button on the
remote handheld transmitter (see Diagram 1). An
audible beep should be heard from the receiver.
2. After approximately 4 seconds the spark ignition
system will spark for 60 seconds to light the pilot.
3. The unit will turn on.
58
| Gi29 Direct Vent Gas Insert
Shutdown Procedure
1. Press the ON/OFF button on the remote
2. If service is to be performed - you must discon-
nect power and shut off gas to the unit.
First Fire
The first fire in your stove is part of the paint curing
process. To ensure that the paint is properly cured,
it is recommended that you burn your fireplace for
at least four (4) hours the first time you use it, with
the fan on. The unit will release an odour caused by
the curing of the paint and the burning of any oils
remaining from manufacturing. Smoke detectors
in the house may go off at this time. Open a few
windows to ventilate the room for a couple of hours.
The glass panel may require cleaning after the unit
has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
When the glass is cold and the appliance is
lit, condensation may fog the glass. This is
normal and will disappear in a few minutes
as the glass heats up.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
During the first few fires, a white film may
develop on the glass front as part of the
curing process. The glass should be cleaned
or the film will bake on and become very dif-
ficult to remove. Use a non-abrasive cleaner
and NEVER clean the glass while it is hot.
Automatic Convection Fan
Operation
The fan operates automatically once turned on.
Adjust the fan speed with the remote. The fan will
turn on as the stove comes to operating temperature.
After the unit is turned off and cooled to below
a useful heat output range, the fan will shut off
automatically.
On/Off Switch
With the pilot on, turn the switch to the right to
turn the burner on. Moving the switch to the left
will turn the burner off.
• This ON/OFF switch will be located on the
lower left-hand side of the appliance as
shown above.
• This ON/OFF switch overrides the remote
functionality. Ensure switch is left in ON
position when using the remote control.
Advertisement
Table of Contents
