Table of Contents
Advertisement
Fan Replacement
• To access the side and rear panels, disconnect the gas and venting (see the venting and flue installation sections in this manual for steps). You cannot
access the blower from the front of the appliance.
1. Shut the power off.
2. From the back of the unit, remove the six screws, then lift the fan
mount plate out.
3. Remove the electrical access panel from the left side of the insert by
removing five screws.
4. Disconnect the green ground wire on the right side of the unit (refer to
wiring diagram).
Neutral/Neutre
Green/Vert
Live/
Sous
tension
IFC Board/
Panneau IFC
Black/
Noir
5. Remove the fan from the mounting plate by removing four screws from
the outside of the fan access panel.
6. D isconnect the red and black wire from the fan motor and green ground
wire.
7. To install, reverse these steps.
maintenance
Green/Vert
Red/
Black/
Noir
Rouge
Gi29 Direct Vent Gas Insert |
61
Advertisement
Table of Contents
