Table of Contents
Advertisement
Fig.13
T00359
Fig.14
Fig.15
Push button mixer shower
Sealant
Using a suitable sealant, seal the join between
the mounting plate and the wall/tiles to prevent
water entering the wall. (fig.13). Wipe away
any excess sealant which may obstruct the fitting
of the mixer valve.
INSTALLING THE SHOWER
Remove the glass cover, taking care not to
damage the glass.
Offer the mixer shower to the brackets, checking
that the sealing washers are in place and carefully
tighten the nuts. Ensure the distance from the
centre of the connector to the wall is 60mm.
(fig14).
NOTE: The seals provided with this
product must be used.
Care must be taken not to damage the chrome
plated surface.
Press the cover into place onto the mixer shower,
taking care not to damage the glass (fig15).
10
Advertisement
Table of Contents
