Installing A Gbic-Npe-G1 - Cisco NPE-175 Installation And Configuration Manual

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Installing a GBIC—NPE-G1
Use the instructions in this section to install a GBIC in the NPE-G1.
Figure 7-11
1
2
3
Step 1 Turn the GBIC so the label side is up and the alignment groove is down.
Note
Insert the GBIC into GBIC port 0/1, 0/2, or 0/3. Repeat this step if you are installing more than one
Step 2
GBIC.
Note
You are finished installing the GBICs. For more information on cabling or specifications, see the
"Gigabit Ethernet GBIC Connection Equipment" section on page
We strongly recommend cleaning all optical fiber connections before connecting optical cables to
Note
equipment. For information about cleaning optical connectors, see the
Procedures for Fiber-Optic Connections
Fiber-Optic Connections
Go to the
installing the NPE-G1 or NPE-G2 in the chassis.
OL-4448-12
Installing a GBIC in the NPE-G1
5
1
GBIC
Alignment groove
GBIC port 0/1
The GBIC is keyed so that it cannot be inserted incorrectly.
Do not remove the GBIC plugs until you are ready to install the cables.
document.
"Inserting the NPE-G1 or NPE-G2 into the Router" section on page 7-28
Network Processing Engine and Network Services Engine Installation and Configuration
3
2
E T H E R
N E T 0
/ 1
R X
G B I C
4 GBIC port 0/2
5 Plug
document and the Compressed Air Cleaning Issues for
Installing the NPE-G1 or NPE-G2
G I G A B
I T E T H
E R N E T
L I N K
T X
E N
R J 4 5
R X
5-13.
Inspection and Cleaning
for instructions on
4
0 / 2
G B I C
7-23