Installing The Npe-G1 Or Npe-G2; Basic Guidelines - Cisco NPE-175 Installation And Configuration Manual

Installing the NPE-G1 or NPE-G2

Installing the NPE-G1 or NPE-G2
To install the NPE-G1 or NPE-G2 in the router, use the following procedures:
•
•
•
•
•
•
•
•
•
•

Basic Guidelines

If you have difficulty installing a network processing engine or I/O controller in the lowest slot of a Cisco
Note
7200 VXR router that is rack-mounted, remove the port adapters, network processing engine and I/O
controller from the chassis and reinstall them. Install the network processing engine and I/O controller
in the lowest slots first, then populate the slots above them, in a bottom-to-top order.
Use the following guidelines when installing the NPE-G1 or NPE-G2:
Ensure that the router is powered down and the input power cable is disconnected from the router and
Step 1
the power source. See the
page
Step 2 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Remove the NPE-G1 or NPE-G2 from its static shielding bag.
Step 3
When touching the NPE-G1 or NPE-G2, use both hands, grasp the NPE-G1 or NPE-G2 by its metal
Step 4
carrier edges, and orient it so that its printed circuit board components face upward.
Handle the NPE-G1 or NPE-G2 by the carrier edges and handle only; never touch the printed circuit
Caution
board components or connector pins.
Network Processing Engine and Network Services Engine Installation and Configuration
7-18
Basic Guidelines, page 7-18
Installing a CompactFlash Disk, page 7-19
Installing a USB Flash Memory Module or eToken—NPE-G2, page 7-19
Installing an SFP Module—NPE-G2, page 7-20
Installing a GBIC—NPE-G1, page 7-23
Replacing the DIMM on the NPE-G2, page 7-24
Upgrading the SDRAM SODIMMs on the NPE-G1 (Optional), page 7-26
Inserting the NPE-G1 or NPE-G2 into the Router, page 7-28
Attaching the Rear Cable-Management Brackets and Cables (Optional), page 7-29
Reconnecting Input Power and Powering Up the Router, page 7-35
"Powering Down the Router and Disconnecting Input Power" section on
7-8.
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
OL-4448-12