C H A P T E R 7 Npe-G1 And Npe-G2 Installation And Configuration Information; Preparing For An Upgrade - Cisco NPE-175 Installation And Configuration Manual

Preparing for an Upgrade

Before you begin any removal or installation procedure, read
Tip
Also, for the NPE-G1, see the
http://www.cisco.com/en/US/products/hw/routers/ps341/prod_installation_guide09186a00805e396a.ht
ml
For the Cisco uBR7200-NPE-G1, see the
following URL:
http://www.cisco.com/en/US/products/hw/cable/ps2217/prod_pre_installation_guide09186a008017bde
6.html
Preparing for an Upgrade
Cisco IOS Release 12.2 changed the behavior of the ROM monitor (ROMmon) during the bootup
Note
sequence. See the
Upgrading to the NPE-G1 or NPE-G2 is a different procedure than previous processor upgrades because
of the following considerations:
•
•
•
If you are upgrading to an NPE-G2 from an NPE-G1, you do not need to perform the following
Note
procedure.
To ensure a smooth upgrade, perform the following procedure only if you are upgrading to an NPE-G1
or NPE-G2 from an NPE-400 or earlier network processing engine.
Network Processing Engine and Network Services Engine Installation and Configuration
7-2
"Boot Changes in Cisco IOS Release 12.2" section on page 10-2
The NPE-G1 and NPE-G2 contain an I/O controller, which includes the bootflash and NVRAM
memory. After you install the NPE-G1 or NPE-G2 in a chassis, you can no longer access the
bootflash and NVRAM on the I/O controller. You therefore must make the existing Cisco IOS
software image and configuration files available to the NPE-G1 or NPE-G2, either by putting these
files on a CompactFlash Disk or on a TFTP server.
The NPE-G1 and NPE-G2 include three Gigabit Ethernet interfaces. If you want to use these
interfaces to replace the Ethernet or Fast Ethernet interfaces on the existing I/O controller, you must
configure the new interfaces before they can be used to access the network. If you are also removing
the existing I/O controller, you must remove the configuration for its Ethernet or Fast Ethernet
interfaces.
Note The NPE-G2 provides a Fast Ethernet Management port, as well as three RJ-45 Gigabit
Ethernet ports.
The NPE-G1 and NPE-G2 use Type 1 CompactFlash Disk memory instead of the Type 2 Flash Disk
memory used in existing I/O controllers. You must transfer any information currently saved on Flash
Disks to CompactFlash Disks so that it can be used after the upgrade to the NPE-G1 or NPE-G2.
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
NPE-G1 Read Me First document, at the following URL:
Cisco uBR7200-NPE-G1 Read Me First
Chapter 8, "Preparation for Installation."
document, at the
for more information.
OL-4448-12