Installing The Cables - Cisco uBR10-MC5X20H Quick Start Manual

Installing the Cables

1
Figure 4
attached to one end and 25 F connectors attached to the other end. This cable is 9.84 feet (3 m) long and
the part number is CAB-RFSW520QTPMF2.
Figure 4
1 F Connectors
Customers purchasing custom-length quad-shield coaxial cable bundles from third party vendors can
Note
purchase spare Universal Cable Holders and spare RF switch header blocks from Cisco. Please refer to
Table 3
Tools required for cable installation include:
•
Also see
Note The following instructions describe the connection process for the customized RF cables and the
maintenance of the Cisco preconfigured cable bundles.
Installing the Cables
The UCH must be used for all Cisco uBR10-MC5X20S/U/H line card cable connections. Failure to use
the UCH may cause permanent damage to the line card connectors and result in low or no RF output.
Step 1 Loosen the top screws and slide open the lock bar. (If the UCH2 is already installed in the line card, use
a screwdriver to slide open the bar. See
Cabling the Cisco uBR10-MC5X20S/U/H Cable Interface Line Card with Universal Cable Holder—UCH2
4
RF Switch Header Blocks
shows the cable bundle for RF switch to HFC plant that has two RF switch header blocks
Cable Bundle with RF Switch Header Blocks and F Connectors
for the applicable Cisco part numbers.
1/4-in. slotted screwdriver and T-10 TORX driver
"Tool Manufacturers and Part
2 UCH2
1
2
2 RF Switch Header Blocks
Numbers."
Figure 8.)
OL-24878-01