Cisco NPE-175 Installation And Configuration Manual page 108

Installing the NPE-G1 or NPE-G2
Figure 7-10 Inserting an SFP Module into the NPE-G2 Gigabit Ethernet Port 0/1
2
1
SFP port 0/1
Use the following procedure to install an SFP module in the NPE-G2:
Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Step 1
Locate the label on the SFP module and turn the SFP module so the label is on top and the alignment
Step 2
groove is down.
Note
Step 3 Insert the SFP module into SFP port 0/1, 0/2, or 0/3. The SFP module snaps into place when you have
completely and properly inserted it.
Repeat Step 2 if you are inserting a second or third SFP module.
Step 4
Note Do not remove the plug from the SFP module optical bores until you are ready to install the network
interface optical fiber cable. Save the plug for future use.
We strongly recommend cleaning all optical fiber connections before connecting optical cables to
Note
equipment. For information about cleaning optical connectors, see the
Procedures for Fiber-Optic Connections
Fiber-Optic Connections
This completes the SFP module installation procedure. For information on inserting the NPE-G2 into the
chassis, see the
Network Processing Engine and Network Services Engine Installation and Configuration
7-22
L I N K
A C T V
E N
G IG A B IT
E T H E R
N E T 0 /
1
L IN K
A C T V
E N
R J 4 5
R J 4 5
The SFP module is keyed so that it cannot be inserted incorrectly.
document.
"Inserting the NPE-G1 or NPE-G2 into the Router" section on page
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
1
G IG A B IT
E T H E R
N E T 0 /
2
L IN K
A C T V
E N
2
SFP module
document and the
Inspection and Cleaning
Compressed Air Cleaning Issues for
7-28.
OL-4448-12