Installing The Rear Cable-Management Brackets On A Rear-Mounted Router (Optional) - Cisco NPE-175 Installation And Configuration Manual

Installing the NPE-G1 or NPE-G2
Figure 7-19
1
1
If the back of the router protrudes from the rack, place the cable-management brackets against the router
Step 1
as shown in
Insert two screws into each bracket, and tighten them to the router.
Step 2
Step 3 Insert the GBIC, SFP module, or RJ-45 cables into the interface ports on the NPE-G1 or NPE-G2.
Place the cables through the cable-management brackets.
Step 4
You have finished installing the cable-management brackets. Go to the
Powering Up the Router" section on page

Installing the Rear Cable-Management Brackets on a Rear-Mounted Router (Optional)

Use the instructions in this section to attach the cable-management brackets if you have a rear-mounted
Cisco 7200 VXR router.
Network Processing Engine and Network Services Engine Installation and Configuration
7-32
Installing the Rear Cable-Management Brackets with an NPE-G1 or NPE-G2—Router
Front-Mounted
G I G A B I T E T H E R N E T 0 / 1
L I N K
E N
R J 4 5 R X
G B I C T X
Screws
Figure 7-19.
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
G I G A B I T E T H E R N E T 0 / 1
G I G A B I T E T H E R N E T 0 / 1
NETWORK PROCESSING ENGINE - G1
L I N K
L I N K
C P U
R E S E T
E N
E N
R J 4 5
R X G B I C T X R J 4 5
R X G B I C T X
C O M PA C T F L A S H
7-35.
1
S L O T
A C T I V E
POWER
OK CONSOLE AUX
"Reconnecting Input Power and
OL-4448-12