Cisco NPE-175 Installation And Configuration Manual page 185

Chapter 9 Removing and Installing the NPE or NSE
Figure 9-9
1 Release latches
Note
With the DIMM socket latches open, grasp the ends of the DIMM between your thumbs and forefingers
Step 5
and pull the DIMM completely out of the socket. (See
Figure 9-10
1
Notch
Handle the edges of the DIMM only; avoid touching the memory modules, pin or traces (the metal
fingers on the connector side of the DIMM). (See
OL-4448-12
Opening DIMM Socket Latches
1
The SDRAM DIMM sockets on the NPE-175, NPE-225, and NPE-300 are parallel to the circuit
board. They are not tilted at an angle.
Removing the DIMM
1
Network Processing Engine and Network Services Engine Installation and Configuration
Removing and Replacing the NPE or NSE
2
2 SDRAM DIMM
Figure 9-10.)
2
2
Metal fingers
Figure 9-11.)
9-15