Changing Preferences To Choose The Other Rommon Image; Troubleshooting The Upgrade - Cisco NPE-175 Installation And Configuration Manual

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
It is advisable to load a known good Cisco IOS image after a ROMmon upgrade.
Note

Changing Preferences to Choose the Other ROMmon Image

To use the other ROMmon image, use one of the following commands to make the change depending on
whether you are in Cisco IOS or in ROMmon:
•
•

Troubleshooting the Upgrade

This section contains sample error messages that appear if an upgrade fails, or if an upgrade is
successful, but the upgrade image is corrupted.
OL-4448-12
Running new upgrade for first time
System Bootstrap, Version 12.2(20031011:151758) [biff]
Copyright (c) 1994-2003 by cisco Systems, Inc.
ROM:Rebooted by watchdog hard reset
C7200 platform with 1048576 Kbytes of main memory
Upgrade ROMMON initialized
rommon 1 >
In Cisco IOS, use the upgrade rom-monitor preference command to change to the other ROMmon
image:
upgrade rom-monitor preference [readonly | upgrade]
Example:
Router: upgrade rom-monitor preference readonly
You are about to mark ReadOnly region of ROMMON for the highest boot preference.
Proceed? [confirm]
Done! Router must be reloaded for this to take effect.
In ROMmon, use the ROMmon CLI rommon-pref command to change to the other ROMmon
image:
rommon-pref [readonly | upgrade]
Example:
rommon 2 > rommon-pref readonly
Network Processing Engine and Network Services Engine Installation and Configuration
Troubleshooting the Upgrade
7-65