Chapter 2: Setting Up The Hardware - Cisco NSS2000 Series Getting Started Manual

Setting up the Hardware
NSS2000 Getting Started Guide
This chapter provides details for installing the NSS hardware. The installation is
broken down into the following steps:
•
Step 1 — Install the Disk Drives: If your NSS does not have disk drives
already installed, follow the steps in this section to insert disk drives into the
NSS chassis.
•
Step 2 — Install the Ethernet Link: Connect the Ethernet cable to your
network.
•
Step 3 — Install the Power: Ensure you have connected the power cable
from the NSS to the applicable power source (UPS or mains).
2
3