Step 3 - Install The Power; Nss-Supported Ups Product Families - Cisco NSS2000 Series Getting Started Manual

Setting up the Hardware
Step 3 — Install the Power
Step 3 — Install the Power
STEP 1
STEP 2
NSS2000 Getting Started Guide
After you connect the Ethernet cable, you are ready to power up the NSS. There
are several possible power configurations. We suggest that a UPS be used since a
sudden loss of power can cause RAID corruption and possible data loss. The
following procedure provides details for each of these options.
To connect the power to the NSS:
Depending on your power configuration, do one of the following:
•
UPS: Connect the power cable to the Power port on the NSS and to an
available port on the UPS. You then need to connect the USB signal cable
from the UPS to the UPS port on the NSS. For more information about
choosing a UPS, refer to the list of supported UPS product families.
•
Mains: Connect the power cable to the Power port on the NSS and to the
mains power.
Press the Power button and confirm the Power LED on the front of the NSS
chassis turns yellow.
Congratulations! You have successfully set up the NSS hardware. You are now
ready to configure the NSS for your unique business storage needs.

NSS-supported UPS Product Families

The NSS supports the following UPS product families:
•
APC Back-UPS Pro USB
•
APC Back-UPS RS USB
•
APC Back-UPS USB
•
APC Back-UPS LS USB
•
APC Back-UPS ES/CyberFort 350
•
APC Smart-UPS USB
2
7