Reset Button (Front Panel); Lan Led (Front Panel) - Cisco NSS2000 Series Getting Started Manual

LEDs & Buttons

Reset Button (Front Panel)

Reset Button (Front Panel)

LAN LED (Front Panel)

NSS2000 Getting Started Guide
The Reset button lets you restore the network setting system defaults or reset the
box.
•
To restore the network setting system defaults: You need to do this if the
configuration interface becomes inaccessible. To reset the network setting
system defaults, shut down the NSS, hold down the Reset button, and then
power up the NSS. When you see the Power LED blink yellow rapidly,
release the Reset button. The network settings are restored to factory
defaults.
•
To reset the box: Press and hold the Reset button while the system is
running until the Power LED begins to blink green. Release the Reset
button.
The LEDs on the front panel indicate the status of the LAN link:
•
Solid Green: The LAN link is up and running at 1000 link speed, but is
currently idle.
•
Flickering Green: The LAN link is up and running at 1000 link speed and is
currently active. The LED flickers off with activity.
•
Solid Yellow: The LAN link is up and running at 10/100 link speed, but is
currently idle.
•
Flickering Yellow: The LAN link is up and running at 10/100 link speed and
is currently active. The LED flickers off with activity.
•
Off: No LAN link is detected.
A
25