Table of Contents
Advertisement
17.3
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
17.4
Adjusting the basic position of the shift lever
Info
The adjustment range of the shift lever is limited.
–
Sit on the vehicle in the riding position and determine
A
distance
shift lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever. (
400692-10
–
1
Loosen nuts
–
Adjust the shift lever by turning shift rod
Guideline
Shift rod adjustment
A
range
Make equal adjustments on both sides.
At least five threaded ends must be screwed into the seat-
ing.
F03806-10
–
Tighten nuts
Guideline
Nut, shift rod
Nut, shift rod
After the nuts have been tightened, the bearings of the shift
rod must be central and aligned identically to each other in
order to ensure freedom of movement in the bearing shells.
–
Check the shift lever to ensure it is functioning properly and
can move freely.
TUNING THE ENGINE 17
between the upper edge of your boot and the
10 ... 20 mm (0.39 ...
0.79 in)
.
2
128 ... 142 mm (5.04 ...
5.59 in)
1
.
M6
M6LH
p. 101)
.
6 Nm (4.4 lbf ft)
6 Nm (4.4 lbf ft)
101
Advertisement
Table of Contents
