Table of Contents
Advertisement
11.3
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
–
Remove screws
–
Take off handlebar clamp
to one side and secure.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
4
port
.
–
Position washers
–
Place the handlebar support
Info
The handlebar support is longer and higher on one
side. This side is marked with marking
–
Mount and tighten screws
Guideline
E01148-11
Screw, handlebar
support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position handlebar clamp
–
Mount screws
Guideline
F02807-10
Screw, handle-
bar clamp
The markings
to the handlebar support and handlebar clamp.
–
First bolt the handlebar clamp with screws
longer, higher side of handlebar support
parts touch.
Info
The longer, higher side of handlebar support
marked with marking
TUNING THE CHASSIS 11
1
.
2
. Take off the handlebar, place
3
6
with nuts
. Remove handlebar sup-
5
.
4
in the required position.
3
6
with nuts
M10
21 Nm (15.5 lbf ft)
2
.
1
, but do not tighten yet.
M8
20 Nm (14.8 lbf ft)
B
on the handlebar are aligned centrally
4
A
.
A
.
.
®
Loctite
243™
1
onto the
so that both
4
is
49
Advertisement
Table of Contents
