Table of Contents
Advertisement
14 WHEELS, TIRES
76
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Insert the spacers.
F02842-10
–
Clean the thread of the wheel spindle and screw
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel
speed sensor
–
Position the fender, and mount and tighten screws
the washers.
F02831-11
Guideline
Screw, fender on
axle clamp
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 51)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
1
and contact
of the spacers.
p. 123)
p. 123)
2
.
M8
3
in the hole.
4
.
M6
7 Nm (5.2 lbf ft)
M6
6
.
M8
2
.
20 Nm (14.8 lbf ft)
®
Loctite
243™
5
with
12 Nm (8.9 lbf ft)
p. 53)
15 Nm (11.1 lbf ft)
Advertisement
Table of Contents
