aventon Pace 350 V2 User Manual page 16

The right pedal (1) is threaded so that it is tightened by turning clockwise.
Apply grease to the thread and
carefully thread the right pedal onto the crank on the right side of the bike slowly and by hand. Do not cross thread or
damage the threads.
The left pedal (2) is reverse-threaded and tightens counterclockwise.
Ensure the remaining pedal has notches
on the exterior of the axle and an "L" stamped into the end of the axle. Apply grease and carefully thread the pedal onto the
left crank by hand slowly. Do not cross thread or damage the threads.
Torque each pedal to 35 Nm.
Identifying marks Right pedal (has a "R" sticker) tightens clockwise. Left pedal (has a "L" sticker) tightens
counterclockwise
Step 9: Remove motor protector and put on the motor protection guard on both sides of back wheel. Then
press the rubber caps on both sides. (Rubber caps are in the accessories box)
Note: Part of plastic motor protector will break and be left inside the freewheel, use a pair of pliers to carefully
remove it.
Step 10: Inflate the tires. Check that the tire beads and tires are evenly seated on the rims. Use a pump with
a Schrader valve and pressure gauge to inflate each tire to the recommended pressure indicated on the tire
sidewall, 30-50 PSI. DO NOT overinflate or underinflate tires.
15