aventon Pace 350 V2 User Manual page 14

Step 5: Put the kickstand down to hold the bike up
Step 6: Ajusting the display and handlebar
(For Pace 500 V2)
A.Centralize the stem to make sure it's aligning to the center line of the front tire. Use 5mm hex key
to tighten the stem cap screw ( 8-12 Nm) ; Use 5mm hex key to tighten the two stem screws on the side
( 5-6 Nm). Cover the stem rubber cap.
B. Stand in front of the bike and clamp front wheel between both legs, verify the handle bars are straight
and in line with the front wheel. Make sure the pinch bolts are tight and you can not turn the stem freely
from the front wheel.
13