aventon Pace 350 V2 User Manual page 15

C. Sit on the saddle, adjust display and handlebar to the desired position and tighten the screws which secure
it to the handlebar.
(For Pace 350 V2)
A. Stand in front of the bike and clamp front wheel between both legs, verify the handle bars are straight and in
line with the front wheel. Make sure the pinch bolts are tight and you can not turn the stem freely from the
front wheel.
B. Sit on the saddle, adjust display and handlebar to the desired position and tighten the screws which
secure it to the handlebar.
(For Pace 350 V2 &500 V2)
C. Ajdust the handlebar height/angle to the desired position then use a 3mm hex key to tighten the screws
sercuring it to the frame.
NOTE: The 4pcs stem screws should be tightened follow picture arrow sequence.
1
2
3
4
Step 7: Use 3mm hex key to tighten the display clamp to desired angle.
Step 8 Pedal Installation
:
Use a pedal wrench to install the pedals. Locate the pedal with a smooth pedal axle enterior and an "R"
stamped into the end of the pedal axle (1, below), which indicate it is the right pedal. The right pedal goes
on the crank on the right side of the bike (which has the drivechain gears and is the same as a rider's right
side when riding).
14