Caple DD910WH Technical Information page 55

 Replace the neon tube
 Check if the neon supports are not damaged and are connected
properly.
 Replace the neon tube supports
 Check if the starter input voltage is 230V

Replace the starter.
THE FILTERS ALARM SIGNAL AFTER 30 HOURS WORKING
DOES NOT RESET WHEN PRESSING THE TIMER KEY
 Disconnect and restore power supply
 Replace the push-button front panel.
 Check the ribbon cable at the control box and extractor
 Replace the main control system board.
THE DOWNDRAFT AIR –CAPACITY IS INADEQUATE
 Check the duct length
 Check the air outlet pipe section
 Make sure there are no obstructions along the pipe
 In a filtered version, check if the charcoal filters, are in good condition.
 Check the efficiency of all speeds in the motor unit.
 Check if the non-return valve flaps can move freely
PROBLEM
LIGHTING DOES NOT LIGHT UP
(ONLY FOR SDD2-L)
Possible solutions
PROBLEM
Possible solutions
PROBLEM
Possible solutions