Related Manuals for Caple DD925CO
Summary of Contents for Caple DD925CO
- Page 1 D o w n d r a f t H o o d I n s t r u c t i o n M a n u a l DD9 25C O Contact Caple on 0117 938 7420 for spare parts or www.caple.co.uk...
-
Page 2: Table Of Contents
C O N T E N T S Introduction Safety Instructions Dimensions Installing the Extractor Grease Filter Removal, Installing the Activated Charcoal Filter Electrical Connection Remote Control Cleaning the Extractor Troubleshooting Aftersales Service Caple Contact Details Instruction manual DD925CO Please keep this instruction manual for future reference... -
Page 3: Introduction
We thank you for taking note of these suggestions before installing and using the appliance. They have been written for your personal safety and the safety of others. Instruction manual DD925CO Please keep this instruction manual for future reference... -
Page 4: Safety Instructions
- Do not ever change or try to change the characteristics of this appliance. This would be a danger. Repairs must be performed only by an authorised Caple engineer. - Always disconnect the hood before carrying out cleaning or maintenance operations. - Page 5 (closed) and the surface above must be at least 400mm. - When handling the Downdraft, never put your hands in the field of action of the extractable unit. Do not touch any moving parts. Instruction manual DD925CO Please keep this instruction manual for future reference...
- Page 6 In the event a downdraft is installed with an external motor, for normal downdraft operation, it is necessary to use an external motor made by Caple. The air collected must not be conveyed into a flue used for smoke or fumes from appliances powered by anything other than electricity (central heating systems, etc.).
- Page 7 Registration can also be completed online by visiting www.caple.co.uk. Ensure you keep your warranty card safe, you may need to show it to Caple Service together with proof of purchase. If you fail to show your warranty card you will incur all repair charges.
-
Page 8: Dimensions
For gas hobs, a minimum 50mm gap must be left beetween the edge of For gas hobs, a minimum 50mm gap must be left between the edge of the gas hob and the the gas hob and the downdraft frame downdraft frame. Instruction manual DD925CO Please keep this instruction manual for future reference... -
Page 9: Installing The Extractor
Downdraft and the ones of the hob are compatible with the cabinet so that the installation can be carried out properly. 3. Make a rectangular opening of 842 x 100mm in the back of the worktop. Instruction manual DD925CO Please keep this instruction manual for future reference... - Page 10 Once the motor is installed, connect the ducting Fig. 1 Fig. 2 to the air outlets. Fig. 3 Fig. 4 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Instruction manual DD925CO Please keep this instruction manual for future reference...
- Page 11 4 pole connector for the neon lamp turn on and push button connector) (Fig.6). Fig. 3 Fig. 4 Fig. 6 Fig. 5 Fig. 6 9. Connect the motor unit cable to the relevant connector on the electrical components box (Fig.7). Fig. 7 Instruction manual DD925CO Please keep this instruction manual for future reference...
- Page 12 (see Fig.8). Install the metal filter cover in this location. (Fig.9). Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11 Instruction manual DD925CO Please keep this instruction manual for future reference...
- Page 13 To purchase the Charcoal filters to work in both ducted mode, with outside evacuation, and recirculating mode. please visit www.caple.co.uk, or call our sales The cooker hood can be mounted in the version with outside discharge of suctioned air: in this case office on 0117 938 1900.
- Page 14 N OT E : Activated charcoal filters are required for this type installation. To purchase the Charcoal filters please visit www.caple.co.uk, or call our sales office on 0117 938 1900. C AU T I O N : Installation must comply with the regulations in force regarding the ventilation of enclosed environments.
-
Page 15: Grease Filter Removal, Installing The Activated Charcoal Filter
WA R N I N G : After having replaced the charcoal filters, ensure the front stainless steel panel is re-applied, otherwise the downdraft will not be able to function. Instruction manual DD925CO Please keep this instruction manual for future reference... -
Page 16: Electrical Connection
The appliance must be fed through a differential protection device (RCD), with a nominal residual current not exceeding 30mA. If the power cord is damaged, call the Caple after-sales service to avoid any risk. WA R N I N G : ›... - Page 17 Check that: › Power is enough. › Feeder lines (mains) are in good condition. › The cable diameter complies with installation regulations. Instruction manual DD925CO Please keep this instruction manual for future reference...
-
Page 18: Remote Control
Timer HOOD WORKS After 10 minutes from its setup, it allow Remote control used for the remote operation of Caple island hoods: the motor , close the extractable unit an lights off, if on. Push the key again to annul this function TECHNICAL DATA: Alkaline battery powered: 12v mod. - Page 19 Push the key again to annul this function signalled by the flashing LEDs “D” for the set speed. The timer can be cancelled by press- ing the key again. Other functions: Instruction manual DD925CO Please keep this instruction manual for future reference Automatic turn off:...
- Page 20 W A R N I N G : W A R N I N G : Instruction manual DD925CO Please keep this instruction manual for future reference The battery should be replaced every year to guarantee the optimal range of the transmitter.
- Page 21 › If the appliance is working at 3rd speed, it is automatically switched to 2nd speed, after 7 minutes operation. Operation speeds can also be changed during operation. The energy consumption of the appliance in standby mode is lower than 0.5W. Instruction manual DD925CO Please keep this instruction manual for future reference...
-
Page 22: Cleaning The Extractor
Follow these steps in reverse order to insert the active charcoal filter. Replace the used charcoal filter on an average of every six months. Instruction manual DD925CO Please keep this instruction manual for future reference... -
Page 23: Troubleshooting
» The non-return valves of the suctioning unit are free to rotate. The downdraft stops in the middle of Check that: operation. » There is not a power outage. » The omnipolar device has not tripped. Instruction manual DD925CO Please keep this instruction manual for future reference... -
Page 24: Aftersales Service
Any maintenance operation on your appliance should be carried out by: › Either your retailer; › Or another Caple approved engineer or similar qualified person. If a problem still persists and further assistance is required, please contact our Caple after sales team on: T - 0117 938 7420 E - service@caple.co.uk... - Page 25 Instruction manual DD925CO Please keep this instruction manual for future reference...
- Page 26 N OT E S : Instruction manual DD925CO Please keep this instruction manual for future reference...
- Page 27 N OT E S : Instruction manual DD925CO Please keep this instruction manual for future reference...
-
Page 28: Caple Contact Details
Caple Service BS11 8DW Fourth Way T: 0117 938 1900 Avonmouth E: service@caple.co.uk Bristol www.caple.co.uk...
Need help?
Do you have a question about the DD925CO and is the answer not in the manual?
Questions and answers